Anycubic SP Kobra 3 Max/3 max Combo Connection Line

The Anycubic Kobra 3 Series / Kobra 3 Max Printhead Connection Line (Extruder Signal Harness): is the main umbilical wiring harness that carries power, sensor data, stepper motor control signals, and hotend telemetry between the printer's mainboard and the moving printhead toolhead assembly.This high-flex cable is wrapped in a durable, protective silicone sheath designed to handle millions of dynamic motion cycles without copper wire fatigue during high-acceleration 3D printing (20,000 mm/s).
High-Flex Industrial Wiring: Multi-strand copper core bundle designed specifically for continuous motion along the X and Z axes without developing internal wire fractures.
Integrated Right-Angle Connector: Features a heavy-duty, keyed right-angle interface plug that locks securely into the top of the printhead board to prevent loose pin contact under rapid directional shifts.
Unified Power & Data Transport: Houses high-gauge power lines for the 300°C heating element alongside shielded signal wires for printhead thermistors, auto-leveling sensors, and cooling fans.
Abrasion-Resistant Outer Sheath: Sheathed in high-visibility orange silicone/braided tubing that resists heat, snagging against the frame, and wear from friction against the PTFE guide tubes.

Technical Specifications

Compatible Models: Anycubic Kobra 3 / Kobra 3 Combo / Kobra 3 Max
Application Location: Toolhead breakout board to main control chassis
Net Cable Weight: ~65 g to 85 g
Gross Shipping Weight: ~110 g to 130 g (in protective anti-static bag/box)
Cable Length: ~1,100 mm - 1,350 mm (1.1 m – 1.35 m extended)
Outer Harness Diameter: ~6.0 mm - 7.5 mm
Packaging Dimensions: 180 x 120 x 35 mm
Conductor / Sheath Material: High-flex tinned copper, high-temp silicone outer jacket.

Maintenance & Care Tips

Ensure Solid Latch Engagement: When plugging the connector into the toolhead breakout board, press firmly until the locking tab or side screws fully seat. A loose cable connection can trigger Thermal Runaway or Printhead Communication Error alerts.
Bundle with PTFE Guide Tube: Use the factory cable clips to attach the connection line to the main PTFE filament tube. This keeps the cable from drooping onto the heatbed or snagging on printed parts.
Check Strain Relief: Make sure the lower frame connection point retains its strain-relief bracket. Never allow the cable to pull taut at the extreme far corners of the print volume.

Barcode (EAN) 30778

Send us your questions about the product.